Print Page - Why a single source file cannot be debugged?

Title: Why a single source file cannot be debugged?
Post by: xparmenides on December 16, 2012, 09:15:05 AM

Hi,

Codeblocks can compile a single source file (does not be contained in a project), and run the produced executable file. But, Codeblocks can not debug it. That is the debugger can not be started through pressing F8. If in a project, the debugger works well. So, I think this really strange. Is there any way to start the debugger for a single source file?

Title: Re: Why a single source file cannot be debugged?
Post by: Jenna on December 16, 2012, 09:22:31 AM

No !
It's discussed many times in the forum.

Title: Re: Why a single source file cannot be debugged?
Post by: xparmenides on December 16, 2012, 01:28:54 PM

I think it may be supported in future. Is it a very hard work? I have no idea about it, but I really need it.

Title: Re: Why a single source file cannot be debugged?
Post by: MortenMacFly on December 16, 2012, 02:59:22 PM

Quote from: xparmenides on December 16, 2012, 01:28:54 PM
I think it may be supported in future. Is it a very hard work? I have no idea about it, but I really need it.

There are very good reasons not to do it. Search the forums.

Code::Blocks Forums

Developer forums (C::B DEVELOPMENT STRICTLY!) => Contributions to C::B => Topic started by: xparmenides on December 16, 2012, 09:15:05 AM